↓

1960 Impala Sport Sedan Restoration Blog

Project: Flat Broke Flat Top

1960 Impala Sport Sedan Restoration Blog
Home Menu ↓
Skip to primary content
Skip to secondary content
  • Home
  • About the 1960 Impala
Home→Published 2007 → September

Monthly Archives: September 2007

Rear Body Mount Repair – Again!

Posted on September 29, 2007 by Dave Stromberger
3
Previous repair of body mount

Previously I had repaired the body mounts that are located just above the rear axle… the caged nuts inside had spun loose out of their cage and became useless (thank you rust!). I did the repair to these the same … Continue reading →

Posted in ALL, Rust Repair | 3 Replies

Front Suspension Assembly

Posted on September 23, 2007 by Dave Stromberger
1
Upper and Lower Control Arms for the 60 Impala, painted and ready to go.

Finally! We get to put something back together instead of taking it apart! After painting the control arms and associated other pieces with Zero-Rust chassis black, my dad came over and helped me get the new bushings pressed into the … Continue reading →

Posted in ALL, Chassis | 1 Reply

Drivers Side Quarter Panel Patch

Posted on September 6, 2007 by Dave Stromberger
Reply
Drivers side quarter panel patch

Finally got around to installing the quarter panel patch. This time I had double the experience with butt-welding than when I started the other side (experience of one, instead of zero), so this one went together a little better and … Continue reading →

Posted in ALL, Rust Repair | Leave a reply

Wheel House Rust Repair

Posted on September 3, 2007 by Dave Stromberger
Reply
Inner Quarter Panel Fender Lip

The passenger side wheel house lip had some small rust holes in it.. nothing bad, but they were perforated pretty much the whole length, so the proper way to repair this was obviously a new patch, rather than trying to … Continue reading →

Posted in ALL, Rust Repair | Leave a reply
© 2021 - 1960 Impala Sport Sedan Restoration Blog
↑