Passenger Rear Door Bodywork

It was time to start doing some filler work on the doors. I began with the passenger rear door, which is overall pretty straight since I put that good door skin on it back in September, but still its not perfect, especially down low. After shooting the door with some PPG DPLF epoxy primer and scuffing it for adhesion,  I applied some Evercoat Rage Gold. If I had not waited too long after applying the epoxy, I could have put the filler right over the freshly cured epoxy (within the recoat window) for an superior bond and time savings!  looks like a lot of filler, but keep in mind that most of it will get sanded off.


Leave a Reply

Your email address will not be published. Required fields are marked *